Mounting A Mantle On Stud Wall

Attach the template board to the wall using 2 screws on the outermost studs.

Mounting a mantle on stud wall.

If you are working on a stone surface use masonry anchors instead of drywall screws. Studs are evenly spaced behind walls. The nails must be long enough to penetrate at least 1 inch into the drywall. Run bolts through the corbel and the stud.

Install a finishing nail into each of the pilot holes with a nail gun or hammer. When you are hanging heavy objects such as a mantel you want to make sure that you hang the object on the studs. For stone or brick walls insert the lag bolts sleeves into the pilot holes then drive the lag bolts into the sleeves with a lag screwdriver. Wall studs are meant to support and hold up dry wall on interior walls.

Complete the rest of the fireplace. Stud supported corbel method start with corbels that are. My dad was kind enough to come to help scott hang the wood mantle while i snuck out with my mom. These nails will secure the mantle in place.

So full confession i had to call my dad for help on this one. Locate the studs and mark. Fireplace mantel installation was a little above my skillset. Lift the mantle back into place.

2 inches stud width masonry width mantel depth 1 to 2 inches. For best support drive them all. Drill holes half of height of your beam. Drill pilot holes into the template board not attached to the wall at this point at the locations of the studs.

You should use drywall screws in conjunction with the adhesive for the strongest bond. Our beam was 6 tall so nate drilled down 3 determine desired height of your mantel. For drywall use a hammer to tap a wall anchor into each pilot hole not entering a wall stud. The mantel needs to anchor to the studs in the wall above the fireplace.

Carefully cut out a tight notch from the corbel in which the stud will sit. Brackets will need to be screwed in but mounting boards can be attached to the wall with a construction grade adhesive. Holding your drill at a 45 degree angle downward drill a pilot hole through the shelf and drywall and into the stud. Squeeze a moderate amount of adhesive into each of the holes in the back of the mantel then lift the mantel and position it into place aligning the holes in the back of the mantel with the.

Drive 1 2 or 3 4 inch rebar rods or lag screws into pilot holes drilled into the studs. Secure the mounting bracket to the wall.