Mounting Shutters On Vinyl Siding

To avoid warping don t attach the shutters tightly.

Mounting shutters on vinyl siding.

Tap the shutter fastener gently with a hammer to snug the shutter against the siding. After removing the shutter drill a hole at each mark. To remove shutters do not attempt to pull out the shutter spikes. Most vinyl siding is made to imitate wood lap siding so the lap of the siding is measured at the bottom of the simulated wood panel where the real wood would overlap each other.

Be careful not to drill into the wall. Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw. Push shutter locks through the holes in the shutter and into the hole in the wall surface. Step 3 add these two measurements together then add 1 2 inch.

Use a hammer to gently tap the fasteners to snug the shutter to the siding. Installing in vinyl siding. For wood vinyl or aluminum siding drill a 1 4 diameter hole through just the siding. Vinyl siding expands and contracts with the weather.

But the only way to fasten the shutters is to drill into the siding. Repeat this process for each shutter you ll be installing. Use a level to ensure that you are hanging shutters at an even height on either side of each window. Best solid surface shower pan to be about inches high.

Do not over tighten or this will cause the shutter to dimple. Mark the locations of the mounting holes on the building. Overtightening fasteners during shutter installation can create warping or dimples on the surface of vinyl. Also drill the hole in the siding 1 4 inch larger than the fastener.

So i don t really want to do that because if it doesn t work out then i have holes in my siding. Place the vinyl shutter next to the window where you plan to install. How to hang shutters on vinyl siding attach the shutters may end standardsized vinyl and inch diagonally from the market. Reposition the shutter.

Measure the thickness of the lap on the siding. Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface.