If the opener is adjusted properly the garage door will move up and down in an even motion.
My garage door opens crooked.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
The door might be hard to open and close due to it binding.
By pushing the door back into position you should have made the vertical track straighten.
A garage door that s out of alignment can be very dangerous.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
A crooked or off balanced door.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Regular adjustment will prevent a crooked door.
Your garage door is likely the largest opening on your home s exterior so it s important to have the peace of mind that it is functioning properly.
Warping of the door will also cause it to run crooked and stick in the tracks.
Without proper adjustment however the unit may run along the tracks unevenly.
To make fine adjustments try adjusting the lifting cable instead of the spring.
5adjust the lift cable.
One of the most likely culprits when you have a crooked garage door is a broken torsion spring.
Any of these situations indicate that one or both garage door tracks need to be aligned.
Push the door push the door back to adjust the door and get the center aligned again.
Here are three possibilities.
Why does my garage door reverse as soon as it hits the floor.
The cable is attached to the door and runs to an s hook that attaches to the track support.
Garage doors which have become crooked or wonky may be suffering from jumped cables which is when one or both cables have loosened from the cable drums and started to unwind.
There may be a large gap of space between the stop molding and the door.
This will cause the unit to stick.